Specifications

174 Implementing IBM System Networking 10Gb Ethernet Switches
Run show portchannel hash to verify the global hash parameters shown in Example 5-20.
Example 5-20 Display trunk hashing parameters
AGG-1#show portchannel hash
Current L2 trunk hash settings:
smac
Current L3 trunk hash settings:
sip dip
Current ingress port hash: enabled
Current L4 port hash: disabled
AGG-1#
ACC-1#show portchannel hash
Current Trunk Hash settings:
smac
ACC-1#
4. Verify the trunk group configuration.
Run the commands in this section to verify the trunk configuration and status.
Verify the trunk group status by running show portchannel [information] or show
portchannel <number> [information]. The output of this command is shown
in Example 5-21.
Example 5-21 Display trunk group status information
AGG-1#show portchannel information
PortChannel 1: Enabled
Protocol - Static
Port State:
17: STG 101 forwarding
18: STG 101 forwarding
PortChannel 2: Enabled
Protocol - Static
Port State:
19: STG 103 forwarding
20: STG 103 forwarding
PortChannel 3: Enabled
Protocol - Static
Port State:
1: STG 100 forwarding
5: STG 100 forwarding
AGG-1#
IP has: Source IP and destination IP hash is enabled by default on
RackSwitch G8264 switches.
Important: Example 5-21 is a template. Complete the configuration of trunks for all the
reference architecture switches according to the details provided in Chapter 3,
“Reference architectures” on page 107.