Specifications

144 Implementing IBM System Networking 10Gb Ethernet Switches
After you complete the POST process and enable the ports, click Configuration, and the
window shown in Figure 4-8 opens.
Figure 4-8 I/O Module tasks menu on the AMM
From this menu, you can identify the switch on one of the high speed bays. In our case, the
High Speed Switch (HSS) was installed in bay 7 of the BladeCenter-H chassis.
4.4.2 Setting an IP address
In Figure 4-8, you can also configure the management IP address, the subnet mask, and the
gateway to make the switch visible to the management network. This IP address is the one
that you connect to over telnet or SSH to access the console. Use the settings shown
in Figure 4-8.