Specifications

128 Implementing IBM System Networking 10Gb Ethernet Switches
After your terminal console is ready, you can plug in the power cables of the switch. The
switch automatically powers on. The switch starts the boot process and you see messages
on the console, as shown in Figure 4-4
Figure 4-4 Initial screen of an IBM RackSwitch G8124-E
4.3.1 Logging on to the switch
You must log on to the switch as admin to perform the initial setup.
Terminal connection: Depending on your guest operating system, the terminal might look
different, and the connection options for the serial port might also change. See your
operating system help for troubleshooting any issues with the terminal connection to
the switches.
Changing the password: The default password is “admin”. Remember to change this
password to secure your infrastructure. For instructions about how to change the
password, see “User management” on page 137.