Installation guide

RackSwitch G8000 Installation
BPP-00007-01, December 2009 Chapter 2: Installing the RackSwitch G8000
 39
6. When a cable is connected and a valid link is established, the XGE Link LEDs on the switch’s front
panel light up, as follows:
 XGE Link LEDs 1 and 2 correspond to module ports on the front panel, as shown below:
Figure 16 Front Panel XGE Port Assignments
 XGE Link LEDs 3 and 4 correspond to module ports on the rear panel, as shown below:
Figure 17 Rear Panel XGE Port Assignments
Port 49
XGE LED 1
Port 50
XGE LED 2
Port 51
XGE LED 3
Port 52
XGE LED 4