Installation guide

RackSwitch G8000 Installation
32
 Chapter 2: Installing the RackSwitch G8000 BPP-00007-01, December 2009
Perform the following steps to mount the RackSwitch G8000 into a 4-post rack.
1. Use the M4 screws to attach a horizontal rail to each side of the switch.
Torque the screws to approximately 30 inch-pounds (3.5 Nm).
Figure 12 Attaching the horizontal rail
2. M6 screws, washers, and clip nuts are used to connect the horizontal rail to the front and rear posts
in the rack. Torque the screws to approximately 30 inch-pounds (3.5 Nm).