Installation guide

RackSwitch G8000 Installation
BPP-00007-01, December 2009 Chapter 2: Installing the RackSwitch G8000
 29
Perform the following steps to mount the RackSwitch G8000 into an iDataPlex rack.
1. Use the M4 screws to attach front and rear mounting brackets to each side of the switch unit. Torque
the screws to approximately 30 inch-pounds (3.5 Nm).
Figure 9 Attaching the iDataPlex mounting brackets
2. M6 screws, washers, and clip nuts are used to attach the alignment plate.
Torque the screws to approximately 30 inch-pounds (3.5 Nm).