Installation guide

RackSwitch G8000 Installation
BPP-00007-01, December 2009 Chapter 1: RackSwitch G8000 Description and Specifications
 17
SFP LEDs
Status LEDs for the SFP ports are described in the following table.
XGE Link LEDs
Figure 4 highlights the system LEDs and XGE port LEDs.
Figure 4 System Status LEDs and XGE Port LEDs
XGE Link LEDs provide the link status for ports on each of the uplink modules, if applicable.
Optional XGE ports one (port 49) and two (port 50) are located in the uplink module on the front
panel. Optional XGE ports three (port 51) and four (port 52) are located in the uplink module on the
rear panel.
Table 8 SFP LEDs Status
LED Solid Green Blink Green Off
Port Link Valid Link N/A No Link
Stacking
MB
MS
Rackswitch G8000
XGE
Link
1
2
3
4
Table 9 XGE Module LEDs Status
LED Solid Green Blink Green Off
Port Link Valid Link N/A No Link