Technical data

RackSwitch G8000 ISCLI Reference
Chapter 4: Configuration Commands
 103BMD00128, September 2009
[no] system notice <1-255 characters>
Configures the contents of the first notice that you want users to see before they login to the con-
sole CLI. This notice can contain up to 255 characters and new lines. All notices are displayed
when you enter the following command: show system
Command mode: Global configuration
[no] banner <1-255 characters>
Configures a login banner of up to 255 characters. After a user or administrator logs into the
switch, the login banner is displayed.
Command mode: Global configuration
terminal-length <0-300>
Configures the number of lines per screen on the terminal console.
Command mode: All except User EXEC
hostname <1-64 characters>
Enables displaying of the host name (system administrator’s name) in the CLI.
Command mode: Global configuration
[no] system dhcp
Enables or disables Dynamic Host Control Protocol for setting the IP address on the management
interface. When enabled, the IP address obtained from the DHCP server overrides the static IP
address.
The default value is enabled.
Command mode: Global configuration
[no] system reset-control
Enables or disables the reset control flag. When enabled, the switch continues to function after a
crash of the main processor, using the last known Layer 2/3 information.
Command mode: Global configuration
show system
Displays the current system parameters.
Command mode: All
Table 4-2 System Configuration Commands
Command Syntax and Usage