Technical data

RackSwitch G8000 ISCLI Reference
102
 Chapter 4: Configuration Commands BMD00128, September 2009
System Configuration
Use these commands to configure switch management parameters.
Table 4-2 System Configuration Commands
Command Syntax and Usage
system date <yyyy> <mm> <dd>
Sets the system date.
Command mode: Global configuration
system time <hh>:<mm>:<ss>
Configures the system time using a 24-hour clock format.
Command mode: Global configuration
system idle <1-60>
Sets the idle timeout for CLI sessions, from 1 to 60 minutes. The default is five minutes.
Command mode: Global configuration
[no] system timezone
Configures the time zone where the switch resides. You are prompted to select your location (con-
tinent, country, region) by the timezone wizard. Once a region is selected, the switch updates the
time to reflect local changes to Daylight Savings Time, etc.
Command mode: Global configuration
show system timezone
Displays the current time zone configuration.
Command mode: All except User EXEC
[no] system daylight
Disables or enables Daylight Savings Time in the system clock. When enabled, the switch will add
an extra hour to the system clock so that it is consistent with the local clock. The default value is
disabled.
Command mode: Global configuration
show system daylight
Displays the current Daylight Savings Time configuration.
Command mode: All except User EXEC
[no] system olddaylight
Enables or disables use of the Daylight Saving Time (DST) rules in effect prior to the
year 2007. The default setting is disabled.
Command mode: Global configuration