Technical data

RackSwitch G8000 ISCLI Reference
Chapter 4: Configuration Commands
 101BMD00128, September 2009
Viewing and Saving Changes
As you use the configuration commands to set switch parameters, the changes you make take
effect immediately. You do not need to apply them. Configuration changes are lost the next
time the switch boots, unless you save the changes.
NOTE – Some operations can override the settings of the Configuration commands.
The Information commands display current run-time information of switch parameters.
Saving the Configuration
You must save configuration settings to Flash memory, so the switch reloads the settings after a
reset.
NOTE – If you do not save the changes, they will be lost the next time the system is
reset/rebooted.
To save the new configuration, enter the following command:
When you save configuration changes, the changes are saved to the active configuration block.
For instructions on selecting the configuration to run at the next system reset, see “Selecting a
Configuration Block” on page 180.
RS G8000# copy running-config startup-config