Technical data

RackSwitch G8000 ISCLI Reference
90
 Chapter 3: Statistics Commands BMD00128, September 2009
Management Processor Statistics
The following table describes the commands used to display statistics about the switch’s man-
agement processor.
Table 3-17 Management Processor Statistics commands
Command Syntax and Usage
show mp memory
Displays system memory statistics.
Command mode: All
show mp packet
Displays packet statistics, to check for leads and load.
Command mode: All
show mp tcp-block
Displays all Transmission Control Protocol (TCP) control blocks (TCB) that are in use.
Command mode: All
To view a sample output, see page 91.
show mp udp-block
Displays all User Datagram Protocol (UDP) control blocks (UCB) that are in use.
Command mode: All
To view a sample output, see page 92.
show mp cpu
Displays CPU utilization for periods of up to 1, 5, and 15 minutes.
Command mode: All
To view a sample output, see page 93.