Technical data

RackSwitch G8000 ISCLI Reference
Chapter 3: Statistics Commands
 85BMD00128, September 2009
Layer 3 Statistics
The following table describes the commands that you can enter to view Layer 3 statistics:
Table 3-13 Layer 3 Statistics Commands
Command Syntax and Usage
clear ip
Clears all IP statistics.
Command mode: All except User EXEC
clear ip arp-cache
Clears IP arp cache.
Command mode: All except User EXEC
show ip igmp groups
Displays source address, port number, version, Vlan and other information.
Command mode: All
show ip igmp counters
Displays IGMP statistics. To view an example of the command output, see page 88.
Command mode: All
clear ip igmp [<VLAN number>]counters
Clears IGMP Snooping statistics counters. Enter the VLAN number to clear statistics on the
selected VLAN.
Command mode: All except User EXEC
show layer3 counters
Dumps all Layer 3 statistics. Use this command to gather data for tuning and debugging switch
performance. If you want to capture dump data to a file, set your communication software on your
workstation to capture session data prior to issuing the dump command.
Command mode: All