Technical data

RackSwitch G8000 ISCLI Reference
Chapter 3: Statistics Commands
 73BMD00128, September 2009
Port 802.1X Authenticator Diagnostics
Use the following command to display the 802.1X authenticator diagnostics for the selected
port:
show interface port {<port alias or number>} dot1x
Command mode: All
System Status: Disabled
Quiet Tx Max Supp Server ReAuth ReAuth
Port Auth Mode Period Period Req Timeout Timeout Status Period
---- --------- ------ ------ --- ------ ------- ------ ------
G force-auth 60 30 2 30 30 disabled 3600
1 force-auth 60 30 2 30 30 disabled 3600
-------------------------------------------------------------------------
G - Global port configuration
Table 3-4 802.1X Authenticator Diagnostics of a Port
Statistics Description
Port The port number.
Auth Mode Displays the Access Control authorization mode for the port.
The Authorization mode can be one of the following:
 force-unauth
 auto
 force-auth
Quiet Period Sets the time, in seconds, the authenticator waits before transmitting an
EAPRequest/ Identity frame to the supplicant (client) after an authentica-
tion failure in the previous round of authentication. The default value is
60 seconds.
Tx Period Sets the time, in seconds, the authenticator waits for an EAP-Response/
Identity frame from the supplicant (client) before retransmitting an EAP-
Request/Identity frame. The default value is 30 seconds.
Max Req Sets the time, in seconds, the authenticator waits before re-authenticating
a supplicant (client) when periodic re-authentication is enabled. The
default value is 3600 seconds.
Supp Timeout Sets the time, in seconds, the authenticator waits for an EAP-Response
packet from the supplicant (client) before retransmitting the EAP-
Request packet to the authentication server. The default value is 30 sec-
onds.