Technical data

BMD00128, September 2009 69
CHAPTER 3
Statistics Commands
You can view switch performance statistics in the user, operator, and administrator command
modes. This chapter discusses how to use the ISCLI to display switch statistics.
Table 3-1 Statistics Commands
Command Syntax and Usage
show snmp-server
Displays the current SNMP configuration parameters. To view an example of the command output,
see page 94.
Command mode: All
show snmp-server counters
Displays SNMP statistics. To view an example of the command output, see page 94.
Command mode: All
clear ntp
Clears Network Time Protocol (NTP) statistics.
Command mode: All except User EXEC
clear ntp primary-server
Clears statistics for the primary NTP server.
Command mode: All except User EXEC
clear ntp secondary-server
Clears statistics for the secondary NTP server.
Command mode: All except User EXEC
show counters
Dumps all switch statistics. Use this command to gather data for tuning and debugging switch per-
formance. If you want to capture dump data to a file, set your communication software on your
workstation to capture session data prior to issuing the dump command. To view an example of the
command output, see page 98.
Command mode: All