Technical data

RackSwitch G8000 ISCLI Reference
Chapter 2: Information Commands
 47BMD00128, September 2009
Link Aggregation Control Protocol Information
Use these commands to display LACP status information about each port on the switch.
Link Aggregation Control Protocol
The following command displays LACP information:
show lacp information
Command mode: All
LACP dump includes the following information for each port on the switch:
 lacp
Displays the port’s LACP mode (active, passive, or off)
 adminkey
Displays the value of the port’s adminkey.
 operkey
Shows the value of the port’s operational key.
Table 2-16 LACP Information Commands
Command Syntax and Usage
show lacp aggregator {<port number>}
Displays detailed information about the LACP aggregator used by the selected port.
Command mode: All
show lacp
Displays the configured global LACP settings.
Command mode: All
show lacp information
Displays a summary of LACP information. To view an example of the command output, see
page 47.
Command mode: All
port lacp adminKey operKey selected prio attached
aggr trunk status
----- ----- ------- ------- ------- ---- --- ----- ----
1 off 0 0 n 32768 -- -- --
2 off 0 0 n 32768 -- -- --
3 off 0 0 n 32768 -- -- --
4 off 0 0 n 32768 -- -- --
5 off 0 0 n 32768 -- -- --
...