Technical data
RackSwitch G8000 ISCLI Reference
44
Chapter 2: Information Commands BMD00128, September 2009
Layer 2 Information
Table 2-14 contains a summary of Layer 2 general information commands. The sections after
the table describe detailed Layer 2 information commands.
Table 2-14 Layer 2 General Information Commands
Command Syntax and Usage
show dot1x
Displays current global 802.1X parameters. To view an example of the command output, see
page 50.
Command mode: All
show dot1x information
Displays 802.1X information.
Command mode: All
show portchannel information
When trunk groups are configured, you can view the state of each port in the various trunk groups.
To view an example of the command output, see page 52.
Command mode: All
show vlan <1-4094>
Displays VLAN configuration information for all configured VLANs, including:
VLAN Number
VLAN Name
Status
Jumbo Frame usage
Port membership of the VLAN
Command mode: All
show layer2 information
Dumps all Layer 2 switch information available (10K or more, depending on your configuration).
If you want to capture dump data to a file, set your communication software on your workstation to
capture session data prior to issuing the dump commands.
Command mode: All