Technical data

RackSwitch G8000 ISCLI Reference
176
 Chapter 6: Boot Options BMD00128, September 2009
Stacking Boot commands
The Stacking Boot commands are used to define the role of the switch in a stack: either as the
Master that controls the stack, or as a participating Member switch. Options are available for
loading stack software to individual Member switches, and to configure the VLAN that is
reserved for inter-switch stacking communications.
copy tftp active-config
Copy configuration file from TFTP server to the active-config partition in the switch.
Command Mode: Privileged EXEC
copy tftp backup-config
Copy configuration file from TFTP server to the backup-config partition in the switch.
Command Mode: Privileged EXEC
copy tftp image1|image2|boot-image
Copy software image file from a TFTP server to the selected flash partition on the switch.
Command Mode: Privileged EXEC
Table 6-2 Stacking Boot commands
Command Syntax and Usage
boot stack mode [master|member]
Configures the Stacking mode for the selected switch.
Command Mode: Privileged EXEC
boot stack vlan <VLAN 2-4094> <asnum 1-12>|master|backup|all
Configures the VLAN used for Stacking control communication.
Command Mode: Privileged EXEC
default boot stack <asnum 1-12>|master|backup|all
Resets the Stacking boot parameters to their default values.
Command Mode: Privileged EXEC
boot stack push-image [boot-image|image1|image2] <asnum 1-12>
Pushes the selected software file from the master to the selected switch.
Command Mode: Privileged EXEC
show boot stack <asnum 1-12>|master|backup|all
Displays current Stacking boot parameters.
Command Mode: Privileged EXEC
Table 6-1 General Boot Commands
Command Syntax and Usage