Technical data

RackSwitch G8000 ISCLI Reference
168
 Chapter 4: Configuration Commands BMD00128, September 2009
Restoring the Active or Backup Switch
Configuration
When the copy active-config running-config command is used, the running
configuration will be replaced with the commands found in the active (saved) configuration
file. The file can contain a full switch configuration or a partial switch configuration.
To restore the active switch configuration, enter:
When the copy tftp running-config command is used, the running configuration
will be replaced with the commands found in the specified configuration file. The file can con-
tain a full switch configuration or a partial switch configuration.
To start the switch configuration download, at the prompt, enter:
Show Active and Backup Configuration
You can view a summary of the current active and backup configuration.
RS G8000# copy active-config running-config
RS G8000# copy tftp running-config
Table 4-62 Active and Backup Information Commands
Command Syntax and Usage
show active-config
Displays the parameters set for the active configuration. To view an example of the command out-
put, see page 171.
Command mode: All
show backup-config
Displays the parameters set for the backup configuration.
Command mode: All