Technical data

RackSwitch G8000 ISCLI Reference
166
 Chapter 4: Configuration Commands BMD00128, September 2009
Update User Priority Configuration
Re-Marking Out-of-Profile Configuration
Table 4-60 User Priority Configuration Commands
Command Syntax and Usage
access-control list {<1-768>} re-mark in-profile dot1p <0-7>
Defines 802.1p value. The value is the priority bits information in the packet structure.
Command mode: Global configuration
[no] access-control list {<1-768>} re-mark in-profile use-tos-prece-
dence
Enable or disable mapping of TOS (Type of Service) priority to 802.1p priority for In-Profile
packets. When enabled, the TOS value is used to set the 802.1p value.
Command mode: Global configuration
show access-control list {<1-768>} re-mark
Displays current Re-Mark In-Profile User Priority parameters.
Command mode: All
Table 4-61 Out-of-Profile Configuration Commands
Command Syntax and Usage
access-control list {<1-768>} re-mark out-profile dscp <0-63>
Sets the DiffServ Code Point (DSCP) of Out-of-Profile packets to the selected value. The switch
sets the DSCP value on Out-of-Profile packets.
Command mode: Global configuration
show access-control list {<1-768>} re-mark
Displays current Re-Mark Out-of-Profile parameters.
Command mode: All