Technical data
RackSwitch G8000 ISCLI Reference
16
Chapter 1: ISCLI Basics BMD00128, September 2009
Each mode provides a specific set of commands. The command set of a higher-privilege mode
is a superset of a lower-privilege mode — all lower-privilege mode commands are accessible
when using a higher-privilege mode. Table 1-1 lists the ISCLI command modes.
Table 1-1 ISCLI Command Modes
Command Mode/Prompt Command used to enter or exit
User EXEC
RS G8000>
Default mode, entered automatically on console
Exit: exit or logout
Privileged EXEC
RS G8000#
Enter Privileged EXEC mode, from User EXEC mode: enable
Exit to User EXEC mode: disable
Quit ISCLI: exit or logout
Global
Configuration
RS G8000(config)#
Enter Global Configuration mode, from Privileged EXEC mode:
configure terminal
Exit to Privileged EXEC: end or exit
Interface IP
Configuration
RS G8000(config-ip-
if)#
Enter Interface IP Configuration mode, from Global Configuration
mode:
interface ip <1-128>
Exit to Global Configuration mode: exit
Exit to Privileged EXEC mode: end
Interface Port
Configuration
RS G8000(config-if)#
Enter Port Configuration mode from Global Configuration mode:
interface port <port number, or range of ports>
Note: Enter a number of ports as follows: interface port 2,7
Note: Enter a range of ports as follows: interface port 2-8
Exit to Global Configuration mode: exit
Exit to Privileged EXEC mode: end
Portchannel
Configuration
RS G8000(config-
PortChannel)#
Enter Portchannel Configuration mode from Global Configuration
mode:
portchannel <trunk group number>
Note: Static trunks are numbered from 1-52. LACP trunks are
numbered from 53-104.
Exit to Global Configuration mode: exit
Exit to Privileged EXEC mode: end
ACL Standard Configuration
RS G8000 (config-std-
nacl)#
Enter the Access Control List (ACL) IP Standard Configuration
mode.
access-list ip standard <1-1000>
Exit to Global Configuration mode: exit
Exit to Privileged EXEC mode: end