Technical data
RackSwitch G8000 ISCLI Reference
158
Chapter 4: Configuration Commands BMD00128, September 2009
DSCP Configuration
These commands map the DiffServ Code Point (DSCP) value of incoming packets to an
802.1p priority value.
Access Control Configuration
Use these commands to create Access Control Lists and ACL Groups. ACLs define matching
criteria used for IP filtering and Quality of Service functions.
Table 4-50 DSCP Configuration Commands
Command Syntax and Usage
qos dscp dot1p-mapping {<DSCP value 0-63>} {<priority (0-7)>}
Maps the DiffServ Code point value to an 802.1p priority value. Enter the DSCP value, followed
by the corresponding 802.1p value.
Command mode: Global configuration
[no] qos dscp enable
Globally turns DSCP mapping on or off.
Command mode: Global configuration
show qos dscp
Displays the current DSCP parameters.
Command mode: All except User EXEC
Table 4-51 General ACL Configuration Commands
Command Syntax and Usage
[no] access-control list <1-768>
Configures an Access Control List.
Command mode: Global configuration
To view command options, see page 162.
[no] access-control group <1-768>
Configures an ACL Group.
Command mode: Global configuration
To view command options, see page 167.
show access-control
Displays the current ACL parameters.
Command mode: All except User EXEC