Technical data

RackSwitch G8000 ISCLI Reference
Chapter 4: Configuration Commands
 147BMD00128, September 2009
LACP Port Configuration
Use the following commands to configure Link Aggregation Control Protocol (LACP) for the
selected port.
Table 4-39 Link Aggregation Control Protocol Port Configuration Commands
Command Syntax and Usage
lacp mode {off|active|passive}
Sets the LACP mode for this port, as follows:
 off: Turns LACP off for this port. You can use this port to manually configure a static trunk.
The default value is off.
 active: Turns LACP on and sets this port to active. Active ports initiate LACPDUs.
 passive: Turns LACP on and set this port to passive. Passive ports do not initiate
LACPDUs, but respond to LACPDUs from active ports.
Command mode: Interface port
lacp priority {<1-65535>}
Sets the priority value for the selected port. Lower numbers provide higher priority.
The default value is 32768.
Command mode: Interface port
lacp key {<1-65535>}
Sets the admin key for this port. Only ports with the same admin key and oper key (operational
state generated internally) can form a LACP trunk group.
Command mode: Interface port
default lacp [key|mode|priority]
Resets LACP port parameters to their default values.
Command mode: Interface port
show interface port {<port number>} lacp
Displays the current LACP configuration for this port.
Command mode: All