Technical data

RackSwitch G8000 ISCLI Reference
142
 Chapter 4: Configuration Commands BMD00128, September 2009
FDB Configuration
Use the following commands to configure the Forwarding Database (FDB).
dot1x max-request {<1-10>}
Sets the maximum number of times the authenticator retransmits an EAP-Request packet to the
supplicant (client). The default value is two.
Command mode: Interface port
dot1x re-authentication-interval {<1-604800>}
Sets the time, in seconds, the authenticator waits before re-authenticating a supplicant (client)
when periodic re-authentication is enabled. The default value is 3600 seconds.
Command mode: Interface port
[no] dot1x re-authenticate
Sets the re-authentication status to on. The default value is off.
Command mode: Interface port
[no] dot1x vlan-assign
Sets the dynamic VLAN assignment for the selected port to on or off. The default value is off.
This feature allows the RADIUS server to specify the VLAN for the port during 802.1x authenti-
cation.
Command mode: Interface port
show interface port {<port number>} dot1x
Displays current 802.1X port parameters.
Command mode: All
Table 4-35 FDB Configuration Commands
Command Syntax and Usage
mac-address-table aging <10-65535>
Configures the aging value for FDB entries, in seconds. The default value is 300.
Command mode: Global configuration
show mac-address-table
Displays current FDB configuration.
Command mode: All
Table 4-34 802.1X Port Commands
Command Syntax and Usage