Technical data

RackSwitch G8000 ISCLI Reference
Chapter 4: Configuration Commands
 139BMD00128, September 2009
dot1x quiet-time {<0-65535>}
Sets the time, in seconds, the authenticator waits before transmitting an EAP-Request/ Identity
frame to the supplicant (client) after an authentication failure in the previous round of authentica-
tion. The default value is 60 seconds.
Command mode: Global configuration
[no] dot1x re-authenticate
Sets the re-authentication status to on. The default value is off.
Command mode: Global configuration
dot1x re-authentication-interval {<1-604800>}
Sets the time, in seconds, the authenticator waits before re-authenticating a supplicant (client)
when periodic re-authentication is enabled. The default value is 3600 seconds.
Command mode: Global configuration
dot1x supplicant-timeout {<1-65535>}
Sets the time, in seconds, the authenticator waits for an EAP-Response packet from the supplicant
(client) before retransmitting the EAP-Request packet from the authentication server.
The default value is 30 seconds.
Command mode: Global configuration
dot1x transmit-interval {<1-65535>}
Sets the time, in seconds, the authenticator waits for an EAP-Response/Identity frame from the
supplicant (client) before retransmitting an EAP-Request/Identity frame.
The default value is 30 seconds.
Command mode: Global configuration
[no] dot1x vlan-assign
Globally sets the dynamic VLAN assignment status to on or off. The default value is off.
This feature allows the RADIUS server to specify the VLAN for the port during 802.1x authenti-
cation.
Command mode: Global configuration
show dot1x
Displays current global 802.1X parameters.
Command mode: All
Table 4-33 802.1X Global Configuration Commands
Command Syntax and Usage