Technical data

RackSwitch G8000 ISCLI Reference
Chapter 4: Configuration Commands
 129BMD00128, September 2009
Port Link Configuration
Use these commands to set port parameters for the port link, such as duplex, flow control, and
negotiation mode for the port link.
NOTE – The speed and mode parameters are fixed for 10 Gigabit and 1 Gigabit Ethernet fixed
ports, and cannot be configured.
[no] shutdown
Disables the port. To temporarily disable a port without changing its configuration attributes, see
see “Temporarily Disabling a Port” on page 130.
Command mode: Interface port
[no] tag-pvid
Enables VLAN tag persistence. When disabled, the VLAN tag is removed from packets whose
VLAN tag matches the port PVID. The default setting is enabled.
Command mode: Interface port
[no] tagging
Enables VLAN tagging for this port. The default setting is disabled.
Command mode: Interface port
show interface port <port number>
Displays the configured port parameters.
Command mode: All
Table 4-24 Port Link Configuration Commands
Command Syntax and Usage
speed {10|100|1000|auto}
Sets the link speed. Not all options are valid on all ports. The choices include:
 10=10 megabits
 100=100 megabits
 1000=1 gigabit
 “Auto,” for auto-negotiation
Command mode: Interface port.
Table 4-23 Port Configuration Commands
Command Syntax and Usage