Technical data

RackSwitch G8000 ISCLI Reference
126
 Chapter 4: Configuration Commands BMD00128, September 2009
User Access Control Configuration
The following table describes user-access control commands.
NOTE – User passwords can be a maximum of 128 characters.
Table 4-21 User Access Control Configuration Commands
Command Syntax and Usage
access user administrator-password
access user operator-password
access user user-password
Allows you to change the password. You must enter the current password for validation.
Command Mode: Global configuration
access user <1-10>
Configures the User ID.
Command mode: Global configuration
access user eject [console-user]
Ejects the current console user from the switch.
Command mode: Global configuration
access user eject <user name> [<IP address>] [<Telnet/SSH port number>]
Ejects the specified user(s) from the switch.
Command mode: Global configuration
access user user-password <1-128 characters>
Sets the user (user) password. The user has no direct responsibility for switch management. The
user can view switch status information and statistics, but cannot make any configuration changes.
Command mode: Global configuration