Technical data

RackSwitch G8000 ISCLI Reference
Chapter 4: Configuration Commands
 125BMD00128, September 2009
Management Network Configuration
These commands are used to define IP address ranges which are allowed to access the switch
for management purposes.
Table 4-20 Management Network Configuration Commands
Command Syntax and Usage
access management-network <IP address> <IP mask>
Adds a defined network through which switch access is allowed through Telnet, SNMP, SSH, or
the browser-based interface (BBI). A range of IP addresses is produced when used with a network
mask address. Specify an IP address and mask address in dotted-decimal notation.
Note: If you configure the management network without including the switch interfaces, it will
cause the Firewall Load Balancing health checks to fail and will create a “Network Down” state on
the network.
Command mode: Global configuration
no access management-network <IP address> <IP mask>
Removes a defined network, which consists of a management network address and a management
network mask address.
Command mode: Global configuration
show access management-network
Displays the current configuration.
Command mode: All except User EXEC
clear access management-network
Removes all defined management networks.
Command mode: Global configuration