Manualshelf

Technical data

ManualsBrandsBlade Network Technologies ManualsComputer AccessoriesG8000
181182183184185186187188189190
BLADE OS 5.1 Application Guide
184
Chapter 13: IGMP BMD00136, November 2009
IGMPv3 Snooping is compatible with IGMPv1 and IGMPv2 Snooping. You can disable snooping
on version 1 and version 2 reports, using the following command:
IGMP Snooping Configuration Example
This section provides steps to configure IGMP Snooping on the switch.
Configure IGMP Snooping
1. Configure port and VLAN membership on the switch.
2. Enable IGMP Snooping.
3. Add VLANs to IGMP Snooping.
4. Enable IGMPv3 Snooping (optional).
5. View dynamic IGMP information.
RS G8000 (config)# no ip igmp snoop igmpv3 v1v2
RS G8000 (config)# ip igmp snoop enable
RS G8000 (config)# ip igmp snoop vlan 1
RS G8000 (config)# ip igmp snoop igmpv3 enable
RS G8000# show ip igmp groups
Note: Local groups (224.0.0.x) are not snooped/relayed and will not appear.
Source Group VLAN Port Version Mode Expires Fwd
-------------- --------------- ------- ------ -------- ----- ------- ---
10.1.1.1 232.1.1.1 2 4 V3 INC 4:16 Yes
10.1.1.5 232.1.1.1 2 4 V3 INC 4:16 Yes
* 232.1.1.1 2 4 V3 INC - No
10.10.10.43 235.0.0.1 9 1 V3 INC 2:26 Yes
* 236.0.0.1 9 1 V3 EXC - Yes
RS G8000# show ip igmp mrouter
VLAN Port Version Expires Max Query Resp. Time QRV QQIC
------ ------- -------- -------- -------------------- --- ----
1 4 V2 static - - -
2 3 V3 4:09 128 2 125