Technical data

BLADE OS 5.0 Command Reference
BMD00142, November 2009 Appendix A: BLADE OS Syslog Messages
 341
SYSTEM Port <port> disabled due to reason code <reason code>
SYSTEM Power Fault {Cleared|Detected}
SYSTEM rebooted (<reason>)[, administrator logged in]
Reason:
 Boot watchdog reset
 console PANIC command
 console RESET KEY
 hard reset by SNMP
 hard reset by WEB-UI
 hard reset from console
 hard reset from Telnet
 low memory
 MM Cycled Power Domain
 power cycle
 Reset Button was pushed
 reset by SNMP
 reset by WEB-UI
 reset from console
 reset from EM
 reset from Telnet/SSH
 scheduled reboot
 SMS-64 found an over-voltage
 SMS-64 found an under-voltage
 software ASSERT
 software PANIC
 software VERIFY
 Telnet PANIC command
 unknown reason
 watchdog timer
SYSTEM Received BOOTP Offer: IP: <IP address>, Mask: <netmask>, Broadcast
<IP address>, GW: <IP address>
SYSTEM Received DHCP Offer: IP: <IP address>, Mask: <netmask> Broadcast
<IP address>, GW: <IP address>
SYSTEM Static route gateway <IP address> is {down|up}
SYSTEM Watchdog threshold changed from <old value> to <new value> seconds
SYSTEM Watchdog timer has been {enabled|disabled}
TEAMING error, action is undefined
TEAMING is down, but teardown is blocked
TEAMING is down, control ports are auto disabled
TEAMING is up, control ports are auto controlled
UPGRADE UFD couldn't be converted to Failover
UPGRADE UpLinkFast is not supported in MSTP/RST/PVRST mode
Thread Message