Technical data

BLADE OS 5.0 Command Reference

340

 Appendix A: BLADE OS Syslog Messages BMD00142, November 2009

SSH Failed login attempt via SSH

SSH New config set

SSH scp<username>(<user type>) {logout|ejected|idle timeout|connection closed}

from {Console|Telnet/SSH}

SSH scp<username>(<user type>) login {on Console|from host <IP address>}

SSH Wrong config file type

SYSTEM BOOTP Offer (continue): Domain name: <domain>

SYSTEM BOOTP Offer (continue): Host name: <host>

SYSTEM BOOTP Offer (continue): Primary DNS: <IP address>, Secondary DNS:

SYSTEM Change fiber GIG port <port> mode to full duplex

SYSTEM Change fiber GIG port <port> speed to 1000

SYSTEM Changed ARP entry for IP <IP address> to: MAC <MAC address>, Port <port>,

VLAN <VLAN>

SYSTEM Could not add L2 multicast entry! L2 table is full.

SYSTEM ECMP route gateway <IP address> is {down|up}

SYSTEM Enable auto negotiation for copper GIG port: <port>

SYSTEM Fan Fault Detected

SYSTEM I2C device <ID> <description> set to access state <state> [from CLI]

SYSTEM Ingress PVST+ BPDU's spotted from port <port>

SYSTEM link {down|up} on management port <port>

SYSTEM link {down|up} on port <port>

SYSTEM **** MAX TEMPERATURE (<temperature>) ABOVE FAIL THRESH ****

SYSTEM **** MAX TEMPERATURE (<temperature>) ABOVE WARN THRESH ****

SYSTEM Port <port> disabled

SYSTEM Port <port> disabled by BPDU Guard

SYSTEM Port <port> disabled by OAM (unidirectional|TX-RX Loop)

SYSTEM Port <port> disabled by PVST Protection

Thread Message