Technical data

BLADE OS 5.0 Command Reference
332
 Appendix A: BLADE OS Syslog Messages BMD00142, November 2009
LOG_CRIT
Log_WARNING
Thread Message
SSH can't allocate memory in load_MP_INT()
SSH currently not enough resource for loading RSA {private|public key}
SYSTEM System memory is at <n> percent
Thread Message
There is an IP address (<IP address>) conflict on the network.
CFG Authentication should be disabled to run RIPv2 in RIPv1 compatibility mode on
interface <interface>.
CFG Multicast should be disabled to run RIPv2 in RIPv1 compatibility mode on
interface <interface>.
HOTLINKS "Error" is set to "Standby|Active"
HOTLINKS "Learning" is set to "Standby|Active"
HOTLINKS "None" is set to "Standby|Active"
HOTLINKS "Side Max" is set to "Standby|Active"
HOTLINKS has no "{Side Max|None|Learning|Error}" interface
IP IGMP: Switch {became|is no longer} a Querier for Vlan <VLAN>
IP IGMP: Switch is [not] elected as Querier for Vlan <VLAN>
IP IGMP: Switch Querier election process started for Vlan <VLAN>
IP IGMP: Switch Querier election type changed for Vlan <VLAN>
IP IGMP: Querier {disabled|enabled} on Vlan <VLAN>
IP IGMP: Warning Querier Source-IP is not configured on Vlan <VLAN> Queries
with Source-IP Zero may be ignored in Querier election process.
IP IGMP: Warning Snooping is not enabled on Vlan <VLAN>, Querier configured
only to send queries.
NTP cannot contact NTP server <IP address> - {Mgmt|Ext-mgt} port unavailable
NTP cannot contact [primary|secondary] NTP server <IP address>