Technical data

BLADE OS 5.0 Command Reference
28
 Chapter 2: First-Time Configuration BMD00142, November 2009
2. For the specified IP interface, enter the IP address in dotted decimal notation:
To keep the current setting, press <Enter>.
3. At the prompt, enter the IP subnet mask in dotted decimal notation:
To keep the current setting, press <Enter>.
4. If configuring VLANs, specify a VLAN for the interface.
This prompt appears if you selected to configure VLANs back in Part 1:
Enter the number for the VLAN to which the interface belongs, or press <Enter> without specifying
a VLAN number to accept the current setting.
5. At the prompt, enter y to enable the IP interface, or n to leave it disabled:
6. The system prompts you to configure another interface:
Repeat the steps in this section until all IP interfaces have been configured. When all interfaces have
been configured, press <Enter> without specifying any interface number.
Default Gateways
1. At the prompt, select a default gateway for configuration, or skip default gateway configuration:
Enter the number for the default gateway to be configured. To skip default gateway configuration,
press <Enter> without typing a gateway number and go to “IP Routing” on page 29.
Current IP address: 0.0.0.0
Enter new IP address:
Current subnet mask: 0.0.0.0
Enter new subnet mask:
Current VLAN: 1
Enter new VLAN [1-4094]:
Enable IP interface? [y/n]
Enter interface number: (1-128)
IP default gateways:
Enter default gateway number: (1-4)