Technical data

BLADE OS 5.0 Command Reference
276
 Chapter 6: The Configuration Menu BMD00142, November 2009
/cfg/l3/ospf/if <interface number>
OSPF Interface Configuration
[OSPF Interface 1 Menu]
aindex - Set area index
prio - Set interface router priority
cost - Set interface cost
hello - Set hello interval in seconds or milliseconds
dead - Set dead interval in seconds or milliseconds
trans - Set transit delay in seconds
retra - Set retransmit interval in seconds
key - Set authentication key
mdkey - Set MD5 key ID
passive - Enable/disable passive interface
ptop - Enable/disable point-to-point interface
enable - Enable interface
disable - Disable interface
delete - Delete interface
cur - Display current OSPF interface configuration
Table 162 OSPF Interface Configuration Options
Command Syntax and Usage
aindex <area index (0-2)>
Configures the OSPF area index.
prio <priority value (0-255)>
Configures the priority value for the G8124’s OSPF interfaces.
(A priority value of 255 is the highest and 1 is the lowest. A priority value of 0 specifies that
the interface cannot be used as Designated Router (DR) or Backup Designated Router
(BDR).)
cost <1-65535>
Configures cost set for the selected path—preferred or backup. Usually the cost is inversely
proportional to the bandwidth of the interface. Low cost indicates high bandwidth.
hello <1-65535>
Configures the interval, in seconds, between the hello packets for the interfaces.
dead <1-65535>
Configures the health parameters of a hello packet, in seconds, before declaring a silent
router to be down.