Technical data

BLADE OS 5.0 Command Reference
BMD00142, November 2009 Chapter 6: The Configuration Menu
 239
/cfg/l2/lacp/port <port alias or number>
LACP Port Configuration
Use the following commands to configure Link Aggregation Control Protocol (LACP) for the
selected port.
[LACP Port 1 Menu]
mode - Set LACP mode
prio - Set LACP port priority
adminkey - Set LACP port admin key
default - Restore default LACP port configuration
cur - Display current LACP port configuration
Table 134 LACP Port Options
Command Syntax and Usage
mode off|active|passive
Set the LACP mode for this port, as follows:
 off: Turn LACP off for this port. You can use this port to manually configure a static
trunk. The default value is off.
 active: Turn LACP on and set this port to active. Active ports initiate LACPDUs.
 passive: Turn LACP on and set this port to passive. Passive ports do not initiate
LACPDUs, but respond to LACPDUs from active ports.
prio <1-65535>
Sets the priority value for the selected port. Lower numbers provide higher priority. The
default value is 32768.
adminkey <1-65535>
Set the admin key for this port. Only ports with the same admin key and oper key (operational
state generated internally) can form a LACP trunk group.
default adminkey|mode|prio
Restores the selected parameters to their default values.
cur
Displays the current LACP configuration for this port.