Technical data

BLADE OS 5.0 Command Reference
BMD00142, November 2009 Chapter 2: First-Time Configuration
23
Stopping and Restarting Setup Manually
Stopping Setup
To abort the Setup utility, press <Ctrl-C> during any Setup question. When you abort Setup, the
system will prompt:
Enter n to abort Setup, or y to restart the Setup program at the beginning.
Restarting Setup
You can restart the Setup utility manually at any time by entering the following command at the
administrator prompt:
Setup Part 1: Basic System Configuration
When Setup is started, the system prompts:
1. Enter y if you will be configuring VLANs. Otherwise enter n.
If you decide not to configure VLANs during this session, you can configure them later using the
configuration menus, or by restarting the Setup facility. For more information on configuring
VLANs, see the BLADE OS Application Guide.
Next, the Setup utility prompts you to input basic system information.
2. Enter the year of the current date at the prompt:
Enter the four-digits that represent the year. To keep the current year, press <Enter>.
The system displays the date and time settings:
Would you like to run from top again? [y/n]
# /cfg/setup
"Set Up" will walk you through the configuration of
System Date and Time, Spanning Tree, Port Speed/Mode,
VLANs, and IP interfaces. [type Ctrl-C to abort "Set Up"]
System Date:
Enter year [2009]:
System clock set to 18:55:36 Wed Jan 28, 2009.