Technical data

BLADE OS 5.0 Command Reference
22
 Chapter 2: First-Time Configuration BMD00142, November 2009
 Optional configuration of IP parameters
 IP address, subnet mask, and VLAN for each IP interface
 IP addresses for default gateway
 Destination, subnet mask, and gateway IP address for each IP static route
 Whether IP forwarding is enabled or not
 Whether the RIP supply is enabled or not
Starting Setup When You Log In
The Setup prompt appears automatically whenever you login as the system administrator under the
factory default settings.
1. Connect to the switch.
After connecting, the login prompt will appear as shown below.
2. Enter admin as the default administrator password.
If the factory default configuration is detected, the system prompts:
Note – If the default admin login is unsuccessful, or if the administrator Main Menu appears
instead, the system configuration has probably been changed from the factory default settings. If
you are certain that you need to return the switch to its factory default settings, see “Selecting a
Configuration Block” on page 317.
3. Enter y to begin the initial configuration of the switch, or n to bypass the Setup facility.
Enter Password:
Blade Network Technologies RackSwitch G8124
18:44:05 Wed Jan 3, 2009
The switch is booted with factory default configuration.
To ease the configuration of the switch, a "Set Up" facility which
will prompt you with those configuration items that are essential to
the operation of the switch is provided.
Would you like to run "Set Up" to configure the switch? [y/n]: