Technical data

BLADE OS 5.0 Command Reference
BMD00142, November 2009 Chapter 6: The Configuration Menu
 199
Temporarily Disabling a Port
To temporarily disable a port without changing its stored configuration attributes, enter the
following command at any prompt:
Because this configuration sets a temporary state for the port, you do not need to use apply or
save. The port state will revert to its original configuration when the G8124 is reset. See the
“Operations Menu” on page 309 for other operations-level commands.
brate <0-262143>|dis
Limits the number of broadcast packets per second to the specified value. If disabled (dis),
the port forwards all broadcast packets.
mrate <0-262143>|dis
Limits the number of multicast packets per second to the specified value. If disabled (dis),
the port forwards all multicast packets.
drate <0-262143>|dis
Limits the number of unknown unicast packets per second to the specified value. If disabled
(dis), the port forwards all unknown unicast packets.
ena
Enables the port.
dis
Disables the port. (To temporarily disable a port without changing its configuration attributes,
refer to “Temporarily Disabling a Port” on page 199.)
cur
Displays current port parameters.
Main# /oper/port <port alias or number>/dis
Table 99 Port Configuration Menu
Command Syntax and Usage