Technical data

BLADE OS 5.0 Command Reference
BMD00142, November 2009 Chapter 6: The Configuration Menu
 189
/cfg/sys/access/mgmt
Management Networks Configuration
This menu is used to define IP address ranges which are allowed to access the switch for
management purposes.
[Management Networks Menu]
add - Add mgmt network definition
rem - Remove mgmt network definition
cur - Display current mgmt network definitions
clear - Clear current mgmt network definitions
Table 91 Management Network Options
Command Syntax and Usage
add <mgmt network address> <mgmt network mask>
Adds a defined network through which switch access is allowed through Telnet, SNMP, RIP,
or the Browser-Based Interface. A range of IP addresses is produced when used with a
network mask address. Specify an IP address and mask address in dotted-decimal notation.
Note: If you configure the management network without including the switch interfaces, the
configuration causes the Firewall Load Balancing health checks to fail and creates a
“Network Down” state on the network.
rem <mgmt network address> <mgmt network mask>
Removes a defined network, which consists of a management network address and a
management network mask address.
cur
Displays the current configuration.
clear
Removes all defined management networks.