Manualshelf

Technical data

ManualsBrandsBlade Network Technologies ManualsComputer equipmentBLADEOS G8124
61626364656667686970
BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 2: Information Commands
67
If RSTP/MSTP/PVRST is turned on, you can view the following bridge information for the
Spanning Tree Group:.
The following port-specific information is also displayed:
Table 27 RSTP/MSTP/PVRST Bridge Parameter Descriptions
Parameter Description
Current Root The Current Root shows information about the root bridge for the
Spanning Tree. Information includes the priority (in hexadecimal
notation) and the MAC address of the root.
Priority (bridge) The Bridge Priority parameter controls which bridge on the network will
become the STP root bridge.
Hello The Hello Time parameter specifies, in seconds, how often the root bridge
transmits a configuration bridge protocol data unit (BPDU). Any bridge
that is not the root bridge uses the root bridge hello value.
MaxAge The Maximum Age parameter specifies, in seconds, the maximum time
the bridge waits without receiving a configuration bridge protocol data
unit before it reconfigures the STP network.
FwdDel The Forward Delay parameter specifies, in seconds, the amount of time
that a bridge port has to wait before it changes from listening to learning
and from learning state to forwarding state.
Aging The Aging Time parameter specifies, in seconds, the amount of time the
bridge waits without receiving a packet from a station before removing
the station from the Forwarding Database.
Table 28 RSTP/MSTP/PVRST Port Parameter Descriptions
Parameter Description
Prio (port) The Port Priority parameter helps determine which bridge port becomes
the designated port. In a network topology that has multiple bridge ports
connected to a single segment, the port with the lowest port priority
becomes the designated port for the segment.
Cost The port Path Cost parameter is used to help determine the designated port
for a segment. Generally speaking, the faster the port, the lower the path
cost. A setting of 0 indicates that the cost will be set to the appropriate
default after the link speed has been auto negotiated.