Technical data

BLADEOS 6.3 Command Reference

434

 Chapter 7: Maintenance Commands BMD00186-B, April 2010

To access dump information, enter:

The dump information is displayed on your screen and, if you have configured your communication

software to do so, captured to a file. If the dump region is empty, the following appears:

TFTP or FTP System Dump Put

Use these commands to put (save) the system dump to a TFTP or FTP server.

Note – If the TFTP/FTP server is running SunOS or the Solaris operating system, the specified

copy flash-dump tftp (or ftp) file must exist prior to executing the

copy flash-dump tftp command (or copy flash-dump tftp), and must be writable (set

with proper permission, and not locked by any application). The contents of the specified file will

be replaced with the current dump data.

To save dump information via TFTP, enter:

You are prompted for the TFTP server IP address or hostname, and the filename of the target dump

file.

To save dump information via FTP, enter:

You are prompted for the FTP server IPv4 address or hostname, your username and password, and

the filename of the target dump file.

Router# show flash-dump-uuencode

No FLASH dump available.

Router# copy flash-dump tftp

Router# copy flash-dump ftp <server filename>