Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 7: Maintenance Commands
 433
IGMP Multicast Routers Maintenance
The following table describes the maintenance commands for IGMP multicast routers (Mrouters).
Uuencode Flash Dump
Using this command, dump information is presented in uuencoded format. This format makes it
easy to capture the dump information as a file or a string of characters.
If you want to capture dump information to a file, set your communication software on your
workstation to capture session data prior to issuing the show flash-dump-uuencode
command. This will ensure that you do not lose any information. Once entered, the
show flash-dump-uuencode command will cause approximately 23,300 lines of data to be
displayed on your screen and copied into the file.
Using the show flash-dump-uuencode command, dump information can be read multiple
times. The command does not cause the information to be updated or cleared from flash memory.
Note – Dump information is not cleared automatically. In order for any subsequent dump
information to be written to flash memory, you must manually clear the dump region. For more
information on clearing the dump region, see page 435.
Table 275 IGMP Multicast Router Maintenance Commands
Command Syntax and Usage
show ip igmp mrouter vlan <VLAN number>
Displays IGMP Mrouter information for a single VLAN.
Command mode: All
show ip igmp mrouter
Displays information for all Mrouters.
Command mode: All
clear ip igmp mrouter
Clears the IGMP Mrouter port table.
Command mode: All except User EXEC