Manualshelf

Technical data

ManualsBrandsBlade Network Technologies ManualsComputer equipmentBLADEOS G8124
421422423424425426427428429430
BLADEOS 6.3 Command Reference
428
Chapter 7: Maintenance Commands BMD00186-B, April 2010
If the switch resets for any reason, the MP trace buffer is saved into the snap trace buffer area. The
output from these commands can be interpreted by Technical Support personnel.
Table 270 Miscellaneous Debug Commands
Command Syntax and Usage
debug debug-flags
This command sets the flags that are used for debugging purposes.
Command mode: All except User EXEC
debug mp-trace
Displays the Management Processor trace buffer. Header information similar to the following
is shown:
MP trace buffer at 13:28:15 Fri May 25, 2001; mask: 0x2ffdf748
The buffer information is displayed after the header.
Command mode: All except User EXEC
debug mp-snap
Displays the Management Processor snap (or post-mortem) trace buffer. This buffer contains
information traced at the time that a reset occurred.
Command mode: All except User EXEC
clear flash-config
Deletes all flash configuration blocks.
Command mode: All except User EXEC