Technical data

BLADEOS 6.3 Command Reference
420
 Chapter 6: Boot Options BMD00186-B, April 2010
Resetting the Switch
You can reset the switch to make your software image file and configuration block changes occur.
Note – Resetting the switch causes the Spanning Tree Group to restart. This process can be lengthy,
depending on the topology of your network.
Enter the following command to reset (reload) the switch:
You are prompted to confirm your request.
Accessing the BLADEOS CLI
The default command-line interface for the G8124 is the ISCLI. To access the BLADEOS CLI,
enter the following command from the ISCLI:
To access the ISCLI, enter the following command from the BLADEOS CLI and reset the G8124:
Users can select the CLI mode upon login, if the following ISCLI command is enabled:
Only an administrator connected through the CLI can view and enable the prompt command.
When prompt is enabled, the first user to log in can select the CLI mode. Subsequent users must
use the selected CLI mode, until all users have logged out.
>> Router# reload
Reset will use software "image2" and the active config block.
>> Note that this will RESTART the Spanning Tree,
>> which will likely cause an interruption in network service.
Confirm reload (y/n) ?
Router(config)# boot cli-mode bladeos-cli
Main# boot/mode iscli
Router(config)# boot cli-mode prompt