Technical data

BLADEOS 6.3 Command Reference
42
 Chapter 2: Information Commands BMD00186-B, April 2010
General System Information
The following command displays system information:
show sys-info
Command mode:
All
Note – The display of temperature will come up only if the temperature of any of the sensors
exceeds the temperature threshold. There will be a warning from the software if any of the sensors
exceeds this temperature threshold. The switch will shut down if the power supply overheats.
System Information at 13:41:04 Fri Jan 20, 2010
Time zone: America/Barbados
Daylight Savings Time Status: Disabled
Blade Network Technologies RackSwitch G8124
Switch has been up for 0 days, 17 hours, 10 minutes and 45 seconds.
Last boot: 20:41:01 Thu Jan 19, 2000 (power cycle)
MAC address: 00:25:03:49:83:00 IP (If 1) address: 0.0.0.0
MGMT-A Port MAC Address: 00:25:03:49:83:ee
MGMT-A Port IP Address (if 127): 172.16.2.45
MGMT-B Port MAC Address: 00:25:03:49:83:ef
MGMT-B Port IP Address (if 128):
Revision: 1
Switch Serial No: CH49380010
Hardware Part No: BAC-00045-02 Spare Part No: BAC-00045-02
Manufacturing date: 09/40
Software Version 6.3.0 (FLASH image1), active configuration.
Fans are in Forward AirFlow, Warning at 85 C and Recover at 100 C
Temperature Sensor 1: 28.0 C
Temperature Sensor 2: 33.0 C
Temperature Sensor 3: 37.75 C
Temperature Sensor 4: 42.75 C
Temperature Sensor 5: 36.50 C
Speed of Fan 1: 8231 RPM
Speed of Fan 2: 8294 RPM
Speed of Fan 3: 8256 RPM
Speed of Fan 4: 8231 RPM
Speed of Fan 5: 8411 RPM
Speed of Fan 6: 8530 RPM
State of Power Supply 1: Off
State of Power Supply 2: On