Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 6: Boot Options
 419
2. Enter the name or the IP address of the FTP or TFTP server:
3. Enter the name of the file into which the image will be uploaded on the FTP or TFTP server:
4. Enter your username and password for the server, if applicable.
5. The system then requests confirmation of what you have entered. To have the file uploaded, enter Y.
Selecting a Configuration Block
When you make configuration changes to the RackSwitch G8124, you must save the changes so
that they are retained beyond the next time the switch is reset. When you perform a save operation
(copy running-config startup-config
), your new configuration changes are placed in
the active configuration block. The previous configuration is copied into the backup configuration
block.
There is also a factory configuration block. This holds the default configuration set by the factory
when your RackSwitch G8124 was manufactured. Under certain circumstances, it may be desirable
to reset the switch configuration to the default. This can be useful when a custom-configured
RackSwitch G8124 is moved to a network environment where it will be re-configured for a
different purpose.
In Global Configuration mode, use the following command to set which configuration block you
want the switch to load the next time it is reset:
Address or name of remote host: <IP address or hostname>
Destination file name: <filename>
User name: {<username>|<Enter>}
image2 currently contains Software Version 6.3.0
that was downloaded at 0:23:39 Thu Jan 1, 2010.
Upload will transfer image2 (2788535 bytes) to file "image1"
on FTP/TFTP server 1.90.90.95.
Confirm upload operation (y/n) ? y
Router (config)# boot configuration-block {active|backup|factory}