Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 5: Operations Commands
 411
VMware Operations
Use these commands to perform minor adjustments to the VMware operation. Use these commands to
perform Virtual Switch operations directly from the switch. Note that these commands require the
configuration of Virtual Center access information (virt vmware vcspec).
Table 265 VMware Operations Commands
Command Syntax and Usage
virt vmware pg [<Port Group name> <host ID> <VSwitch name> <VLAN number>
<shaping-enabled> <average-Kbps> <burst-KB> <peak-Kbps>]
Adds a Port Group to a VMware host. You are prompted for the following information:
 Port Group name
 VMware host ID (Use host UUID, host IP address, or host name.)
 Virtual Switch name
 VLAN ID of the Port Group
 Whether to enable the traffic-shaping profile (1 or 0). If you choose 1 (yes), you are
prompted to enter the traffic shaping parameters.
Command Mode: Privileged EXEC
virt vmware vsw <host ID> <Virtual Switch name>
Adds a Virtual Switch to a VMware host. Use one of the following identifiers to specify the
host:
 UUID
 IP address
 Host name
Command Mode: Privileged EXEC
no virt vmware pg <Port Group name> <host ID>
Removes a Port Group from a VMware host. Use one of the following identifiers to specify
the host:
 UUID
 IP address
 Host name
Command Mode: Privileged EXEC