Technical data

BLADEOS 6.3 Command Reference
380
 Chapter 4: Configuration Commands BMD00186-B, April 2010
VRRP Tracking Configuration
These commands are used for setting weights for the various criteria used to modify priority levels
during the master router election process. Each time one of the tracking criteria is met (see “VRRP
Virtual Router Priority Tracking Commands” on page 375), the priority level for the virtual router is
increased by a defined amount.
Note – These priority tracking options only define increment values. These options do not affect
the VRRP master router election process until options under the VRRP Virtual Router Priority
Tracking Commands (see page 375) are enabled.
Table 239 VRRP Tracking Configuration Commands
Command Syntax and Usage
tracking-priority-increment virtual-routers <0-254>
Defines the priority increment value (0 through 254) for virtual routers in master mode
detected on this switch. The default value is 2.
Command mode: Router VRRP
tracking-priority-increment interfaces <0-254>
Defines the priority increment value for active IP interfaces detected on this switch. The
default value is 2.
Command mode: Router VRRP
tracking-priority-increment ports <0-254>
Defines the priority increment value for active ports on the virtual router’s VLAN. The
default value is 2.
Command mode: Router VRRP
show ip vrrp tracking-priority-increment
Displays the current configuration of priority tracking increment values.
Command mode: All except User EXEC