Technical data

BLADEOS 6.3 Command Reference
378
 Chapter 4: Configuration Commands BMD00186-B, April 2010
Virtual Router Group Priority Tracking Configuration
Note – If Virtual Router Group Tracking is enabled, then the tracking option will be available only
under group option. The tracking setting for the other individual virtual routers will be ignored.
no group
Deletes the virtual router group from the switch configuration.
Command mode: Router VRRP
show ip vrrp group
Displays the current configuration information for the virtual router group.
Command mode: All except User EXEC
Table 237 Virtual Router Group Priority Tracking Configuration Commands
Command Syntax and Usage
[no] group track interfaces
When enabled, the priority for this virtual router will be increased for each other IP interface
active on this switch. An IP interface is considered active when there is at least one active port
on the same VLAN. This helps elect the virtual routers with the most available routes as the
master. This command is disabled by default.
Command mode: Router VRRP
[no] group track ports
When enabled, the priority for this virtual router will be increased for each active port on the
same VLAN. A port is considered “active” if it has a link and is forwarding traffic. This helps
elect the virtual routers with the most available ports as the master. This command is disabled
by default.
Command mode: Router VRRP
show ip vrrp group track
Displays the current configuration for priority tracking for this virtual router.
Command mode: All except User EXEC
Table 236 VRRP Virtual Router Group Configuration Commands
Command Syntax and Usage