Technical data

BLADEOS 6.3 Command Reference
BMD00186-B, April 2010 Chapter 4: Configuration Commands
 377
group advertisement <1-255>
Defines the time interval between VRRP master advertisements. This can be any integer
between 1 and 255 seconds. The default is 1.
Command mode: Router VRRP
[no] group preemption
Enables or disables master pre-emption. When enabled, if the virtual router group is in
backup mode but has a higher priority than the current master, this virtual router will pre-empt
the lower priority master and assume control. Note that even when preemption is disabled,
this virtual router will always pre-empt any other master if this switch is the owner (the IP
interface address and virtual router address are the same). By default, this option is
enabled.
Command mode: Router VRRP
[no] group fast-advertise
Enables or disables Fast Advertisements. When enabled, the VRRP master advertisements
interval is calculated in units of centiseconds, instead of seconds. For example, if adver is
set to 1 and fadver is enabled, master advertisements are sent every .01 second.
When you disable fast advertisement, the advertisement interval is set to the default value
of 1 second. To support Fast Advertisements, set the interval between 20-100 centiseconds.
Command mode: Router VRRP
group enable
Enables the virtual router group.
Command mode: Router VRRP
no group enable
Disables the virtual router group.
Command mode: Router VRRP
Table 236 VRRP Virtual Router Group Configuration Commands
Command Syntax and Usage