Manualshelf

Technical data

ManualsBrandsBlade Network Technologies ManualsComputer equipmentBLADEOS G8124
361362363364365366367368369370
BLADEOS 6.3 Command Reference
370
Chapter 4: Configuration Commands BMD00186-B, April 2010
Bootstrap Protocol Relay Configuration
The Bootstrap Protocol (BOOTP) Relay commands are used to allow hosts to obtain their
configurations from a Dynamic Host Configuration Protocol (DHCP) server. The BOOTP
configuration enables the switch to forward a client request for an IP address to two DHCP/BOOTP
servers with IP addresses that have been configured on the
G8124.
BOOTP relay is turned off by default.
Table 232 Bootstrap Protocol Relay Configuration Commands
Command Syntax and Usage
[no] ip bootp-relay {server1|server2} <IP address>
Sets the IP address of the first or second BOOTP server. To set an IPv4 address, use dotted
decimal notation.
Command mode: Global configuration
ip bootp-relay enable
Globally turns on BOOTP relay.
Command mode: Global configuration
no ip bootp-relay enable
Globally turns off BOOTP relay.
Command mode: Global configuration